SCI Seg3D Mailing List

Text archives Help


Re: [Seg3D] Sweeping a range of conductivity values


Chronological Thread 
  • From: Dana Brooks <brooks@ece.neu.edu>
  • To: seg3d@sci.utah.edu
  • Subject: Re: [Seg3D] Sweeping a range of conductivity values
  • Date: Wed, 14 Jan 2015 09:42:36 -0500
Ayla hi,

good catch ! did you send it to that list? I didn't see it there ? or should I do that ?

best,

Dana

On 1/13/15 3:33 PM, Ayla Khan wrote:
This message belongs in the scirun-users mailing list, and should be answered there.

Thanks,

Ayla

On Jan 13, 2015, at 1:26 PM, Purbasha Garai wrote:

Hello, 

I want to test multiple conductivity values in SCIRUN. 

I have set up a matrix with all the conductivity sets that I want to run  Then I have used the  GetRowOrColumnFromMatrix module to can choose one row at a time.  
Every single time I am trying to run the simulation, SCIRun stops working. 
Since I am not very much familiar with Bash scripting, I am using this network.
Can you please check if my network is correct? I am unsure how can I save leadfield after each iteration(i.e, after going though a set of conductivity) 
 
Regards
Purbasha
<123456789.srn><EPIthelium_change.mat>



Archive powered by MHonArc 2.6.18.

Top of page