shapeworks-dev-support

Text archives Help


[shapeworks-dev-support] SW Studio seg fault


Chronological Thread 
  • From: Allen Sanderson <allen@sci.utah.edu>
  • To: shapeworks-dev-support@sci.utah.edu
  • Subject: [shapeworks-dev-support] SW Studio seg fault
  • Date: Tue, 9 Jun 2020 11:47:32 -0600
  • Ironport-sdr: Dv8uICScBlkw/vg/LleFawDjevxrbsEkIRlXzr/fVHJ/XU9e+Ik9sIsHp7ZjDYAbE9l9avYL9F jY1q+BJLCOKc93lXfHOQ5nnYaoLrQAmOnKEfV+ZSPKp9UXmoNTbPrh9MR5EyqbpVdIov7NtvJk m2SlkuQpKjZlf6+yvKv/QHH+U1iXfbeLmmG0l+A/6vNIYwnonaP0ZL6loW17/S1Cuq4x/O0crl vtfOOv70hkb2CYy1Zw8ElYpg24HePbhzqFCKKaUV6dikZZpXP/mDaAjx4FyToMuppMOkBYCs/Z qCM=
As Alan gave me a template for groups I am loading it and getting a hard crash with the following:

Open SW Studio,
Open the project,
Immediately click on “Difference” SW studio will crash, seg fault.

I can do this consistently. 

However, if I pause until the initial “reconstructed” surface comes up it does not crash.

Also, being these are the initial “reconstructed” surfaces  which are not very good. I ran the reconstruction using the defaults. During this process SW Studio crashed as well.  I am running it again to see if it crashes consistently for this case. As Alan has the data being used I am including my groups.xml file so it can be duplicated. 



Attachment: groups.xml
Description: XML document



Cheers,


Allen



Allen Sanderson

SCI Institute

University of Utah





Archive powered by MHonArc 2.6.18.

Top of page