shapeworks-users

Text archives Help


Re: [shapeworks-users] Running Shapeworks in parallel


Chronological Thread 
  • From: Alan Morris <alan.morris@carma.utah.edu>
  • To: "shapeworks-users@sci.utah.edu" <shapeworks-users@sci.utah.edu>, Elizabeth Jurrus <liz@sci.utah.edu>
  • Cc: "Young, Ryan" <Ryan.Young@seattlechildrens.org>
  • Subject: Re: [shapeworks-users] Running Shapeworks in parallel
  • Date: Thu, 17 Sep 2015 16:22:46 -0600
Hi,

There is a cmake flag, USE_OPENMP that will enable OpenMP parallelization for ShapeWorksGroom and ShapeWorksRun.

cmake -DUSE_OPENMP=ON ....

Alan

On Thu, Sep 17, 2015 at 2:52 PM, Elizabeth Jurrus <liz@sci.utah.edu> wrote:
Hi Ryan - thanks for your question.  Just forwarding it along to the main mailing list. - liz

On 9/17/15 1:27 PM, Young, Ryan wrote:
Hello,

I was wondering if there is a way to get Shapeworks to run in parallel?  I am running it on Centos 6.5 and Ubuntu and can build it from the source again if needed.  Is there a build flag or a way to build against a parallel linear algebra library.

Thanks,
Ryan Young 
CONFIDENTIALITY NOTICE: This e-mail message, including any attachments, is for the sole use of the intended recipient(s) and may contain confidential and privileged information protected by law. Any unauthorized review, use, disclosure or distribution is prohibited. If you are not the intended recipient, please contact the sender by reply e-mail and destroy all copies of the original message.




Archive powered by MHonArc 2.6.18.

Top of page