Chronological Thread 

< Chronological >      < Thread >

---

Hi Kenneth,

This usually happens if the points you are providing for initialization
doesn't lie on the isosurface of the respective distance transforms, as
a visual QC, you might want to load a sample nrrd file in paraview then
load its corresponding points and make sure that the points lie on the
isosurface ...

hope this would help

regards
Shireen

On 01/14/2015 04:31 PM, kmill2803 . wrote:
> I have got the shapeworks software to run with a set of proximal
> femurs with 256 correspondence points. I used the TorusExample files
> as a template.
>
> However when i bump up the correspondence points to 512 or 1024 or
> 2048 I get an itk::Error PowerOfTwoPointTree Point is not contained
> within tree domain.
>
> Attached is the correspondence.xml file. I only changed the number of
> points in this file.
>
>
> Thanks,
> Kenneth Milligan

---

• [shapeworks-users] correspondence points error help, kmill2803 ., 01/14/2015
  • Re: [shapeworks-users] correspondence points error help, kmill2803 ., 01/14/2015
  • Re: [shapeworks-users] correspondence points error help, Shireen Elhabian, 01/14/2015
    • Re: [shapeworks-users] correspondence points error help, kmill2803 ., 01/14/2015
      • Re: [shapeworks-users] correspondence points error help, Shireen Elhabian, 01/14/2015
        • Re: [shapeworks-users] correspondence points error help, kmill2803 ., 01/14/2015
          • Re: [shapeworks-users] correspondence points error help, kmill2803 ., 01/14/2015
            • Re: [shapeworks-users] correspondence points error help, Shireen Elhabian, 01/14/2015
              • Re: [shapeworks-users] correspondence points error help, kmill2803 ., 01/14/2015
              • Re: [shapeworks-users] correspondence points error help, Shireen Elhabian, 01/15/2015

---

Archive powered by MHonArc 2.6.18.