shapeworks-users

Text archives Help


Re: [shapeworks-users] correspondence points error help


Chronological Thread 
  • From: "kmill2803 ." <kmilligan28@gmail.com>
  • To: "shapeworks-use." <shapeworks-users@sci.utah.edu>, Shireen Elhabian <shireen@sci.utah.edu>
  • Subject: Re: [shapeworks-users] correspondence points error help
  • Date: Wed, 14 Jan 2015 16:52:46 -0700
Thanks,

I dont have paraview to be able to visualize isosurface and corresponding points but I am working on getting access to be able install it on the computer i am working on. 

I was wondering why it works for 256 correspondence points. Isnt the points provided for initialization the same for 256 as 2048? Also if this is the case how do I change the initialization poiints.

Thanks again
Kenneth Milligan

On Wed, Jan 14, 2015 at 4:37 PM, Shireen Elhabian <shireen@sci.utah.edu> wrote:

Hi Kenneth,

This usually happens if the points you are providing for initialization
doesn't lie on the isosurface of the respective distance transforms, as
a visual QC, you might want to load a sample nrrd file in paraview then
load its corresponding points and make sure that the points lie on the
isosurface ...

hope this would help

regards
Shireen

On 01/14/2015 04:31 PM, kmill2803 . wrote:
> I have got the shapeworks software to run with a set of proximal
> femurs with 256 correspondence points. I used the TorusExample files
> as a template.
>
> However when i bump up the correspondence points to 512 or 1024 or
> 2048 I get an itk::Error PowerOfTwoPointTree Point is not contained
> within tree domain.
>
> Attached is the correspondence.xml file. I only changed the number of
> points in this file.
>
>
> Thanks,
> Kenneth Milligan



Archive powered by MHonArc 2.6.18.

Top of page